flavtfan Posted December 17, 2020 Posted December 17, 2020 -Racers Edge 121 Titanium -MMAD 14:75.1 Piston -Athena 98mm Cylinder -42.5 Taper bored carb by Sredrum w/MMAD needle setup and epoxied transition ring -Lightspeed Intake and Exhaust Cams -Programable Dyna w/MMAD curves (MR12 and 110) -FCI intake cut and tuned to motor w/new style FCI filter -JJandA hard anodized axle w/DB Fab titanium brake rotor -Stellar +4 swingarm -Kickstart conversion w/cut down wire harness and kill switch -Direct drive lockout w/yamaha emblem cover plate -RIS footpegs -Boyesen High Flow water pump and cover -Fox Evols -Jogaca valved rear shock -Adjustable dogbone link to raise or lower quad in the rear -Pro Taper bars w/ODI grips, extended modquad thumb throttle, and ASV brake and clutch levers -ESR rear brake lever and ESR shifter -22-11-8 SLS rear and mohawk Skat Traks on douglas blue lables -Tuned for both MR12 and 110 (i'll give the tuning setup #'s to the buyer) -Bike does between 61-65.5/39-41.5 depending on dyno and fuel... buyer will get sheets with 110 tune and MR12 tune plus a pale of MR12. -Bottom end was fully rebuilt and has approx 10 hrs on it. Piston and cylinder has about 5 hrs, Head has about 15 hrs. --$5700 or best reasonable offer. -TITLE in HAND Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.