what shop do you recommend?

[sanddan1]

Looking for a shop in the Vegas/Henderson area to do machining services. if there is one that will ship finished products even better.

[EY3BA11]

Mike at GreenValley ATV

Depending on what your doing I would also recommend Glenn at GSS he is the 500 guru but can machine just about anything and has no problem shipping cylinders. He is out of palmdale/lancaster area.

[sanddan1]

Thanks ISBB

[mineurbiz]

Are you willing to ship it? I also think there are a couple shops there in Bullhead.

[2Extreme]

Are you willing to ship it? I also think there are a couple shops there in Bullhead.

Can you provide the names of these shops or any you might know of in Vegas. Thanks

[sanddan1]

I am willing to ship, but if there are shops in BHC, who and where?

[mineurbiz]

I am willing to ship, but if there are shops in BHC, who and where?

I left a guy I know there a message to verify, if not I would ship to KenzCycleTech or Racers Edge in AZ, they are top notch builders! Ken the owner of Kenz and John the owner of RE are both great people, Ken built my bike and I never have to wrench on it, the bike just runs.

Edited March 2, 2010 by mineurbiz

[mineurbiz]

Pass on the machine shops there in BHC, buddy says he would not take the parts to them.

[britincali]

Depending on what your doing I would also recommend Glenn at GSS he is the 500 guru but can machine just about anything and has no problem shipping cylinders. He is out of palmdale/lancaster area.

For a rebore you cant go wrong with glen, without a shadow of a doubt the best rebore guy Ive ever used, just dont go getting talked into any expensive portwork.