Leaderboard

For those of you that know Rebecca, (SKYZ) creator of the "Peeps", had an accident and seriously broke her leg. She had surgery to correct the issue but will be down for quite some time. I know she would appreciate hearingfrom her DDR friends. I just found out tonight. Just don't tell her that I spilled the beans............ Personally I am hoping for her fast and complete recovery!

It can be tuned out. At this point its probably about fixed though. I know when I have dealt with it, I used the alignment tool when putting it together on the side of the trans. The dash lights should come on either way, and if you get it in nuetral (indicated) it should turn over. If it doesnt there may be another problem.

That pigtail/ connector is glued into the switch from the factory. Not sure why but it makes it nearly impossible to unplug without destroying the wiring. I would pay close attention to the wiring and terminals in the connector. I'm sure there is probably a bad connection there because of this. We remove the bolts that attach it to the trans and slide the switch off the selector shaft as the bolts loosen to prevent dealing with this situation. Then just make sure you adjust it properly so it corresponds correctly with the shifter position. Good luck!

I would think that the ppps on the side of the tranz had the electrical dissconnect from it ? that module may require replacment along with the harness connector w/ pigtail (DEALER PARTS ONLY) ...Def start there...Also make sure you did not pich the harness between the bellhousing and the block..